Setting up LXC containers. Unable to bridge network via dnsmasq

Published: 1/02/2018
Setting up LXC containers. Unable to bridge network via dnsmasq
Source: BBS.ARCHLINUX.ORG

Below are the 3 steps to bridge network via dnsmasq - 1. Create the bridge device. 2. Assign an IP address to the bridge device. 3. Configure dnsmasq to listen on the bridge interface IP address. Creating the bridge device is simple: sudo apt-get install bridge-utils sudo brctl addbr br0 sudo brctl addif br0 eth0 eth1 If you want it created automatically, modify /etc/network/interfaces: iface eth0

Read more
Related news
Comment